Home > Offer to Sell > Adhesives and Sealants > Acrylic Adhesives > PAC

PAC

Inquiry
  Post Date: Dec 25,2017
  Expiry Date: Jun 23,2018
  Detailed Description: Cas No. :1327-41-9;101707-17-9;11097-68-0;114442-10-3

【PRODUCT IDENTIFICATION】
Product Name: Pac
Chemical Name: Poly Anionic Cellulose
CAS Number: 9004-32-4
Product Components:

Name Percentage CAS No. EINECS No.
Purity of sodium carboxymethyl cellulose, on dry basis 95% min. 9004-32-4
moisture content 10.0% Max. 7732-18-5 231-791-2
sodium chloride 0 – 5% 7647-14-5 231-598-3

【HEALTH HAZARDS
Recommended Exposure Limits:
Control as Particulate Not Otherwise Classified (PNOC) or Regulated:

OSHA PEL ACGIH TLV*
Respirable Fraction 5 mg/m3 3 mg/m3
Total Dust 15 mg/m3 10 mg/m3

* The value is for inhalable (total) particulate matter containing no asbestos.

Acute Effects of Overexposure:
Skin Contact: May cause slight irritation with prolonged contact with moistened product.
Eye Contact: Dust may cause mechanical irritation.
Inhalation: Non-irritating to mucous membranes, however, breathing high concentration of the dust may cause mechanical irritation of the nose, throat, and upper respiratory tract.
Ingestion: Passes through relatively inert. May cause some gastrointestinal upset. Oral LD50 > 25 g/kg (rats)

Subchronic and Chronic Effect of Overexposure:
No adverse effects have been noted in chronic feeding studies using laboratory animals and humans.

Other Health Effects:
Long term exposure to high dust concentrations may cause non-debilitating lung changes.

Health Hazard Categories:

Animal Human Animal Human
Known carcinogen - - Toxic - -
Suspect carcinogen - - Corrosive - -
Mutagen - Irritant - -
Teratogen - - Target Organ Toxin - -
Animal Human Animal Human
Allergic Sensitizer - - Specify No known applicable information
Highly Toxic - -

Canadian WHMIS:
Specify: Does not meet criteria for any of the above categories.

【FIRST AID MEASURES】
Skin Contact: Wash with plenty of water and soap while removing contaminated clothing. Wash clothing before reuse. If irritation develops or persists, get medical attention.
Eye Contact: In case of contact, immediately flush with plenty of water for at least 15 Minutes, occasionally lifting the upper and lower eyelids. If irritation persists, consult medical personnel.
Ingestion: Do not induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupful of milk or water. Wash mouth out with water. Get medical aid if irritation or symptoms occur.
Inhalation: Move to fresh air immediately. If cough or other symptoms appear, get medical attention.

【PHYSICAL AND CHEMICAL DATA】
Appearance and Odor: Free-flowing white to light yellow powder; odorless
Bulk Density: 300 – 900 kg/m3
Melting Point (ºC): Not applicable
Boiling Point (ºC): Not applicable
Solubility in Water: Soluble
pH (1% solution): 6.0 ~ 8.5
NFPA Rating: Health 1; Flammability 0; Reactivity 0
Vapor Density (Air = 1): Not applicable
Vapor Pressure (mm Hg): Not applicable

【FIRE FIGHTING MEASURES】
Flash Point : Not applicable
Flammable Limits : Not applicable
Extinguishing Media : Water spray, foam, or Halogen
Special Fire Fighting Procedures : In case of insufficient ventilation firefighters should wear self- contained breathing apparatus and full protective gear. Material becomes slippery when contacted with water. During fire, irritating and toxic gases may be generated by thermal decomposition or combustion.
Unusual Fire and Explosion Hazards: Dust/air mixtures may ignite violently upon exposure to sparks or sources of ignition.

【STABILITY AND REACTIVITY DATA】
Incompatibility: Moisture
Conditions to Avoid: Incompatible materials, dust generation, excess heat, exposure to moist or water
Decomposition Products: carbon dioxide, carbon monoxide, irritating and toxic fumes and gases
Hazardous Polymerization: Will not occur
Chemical Stability: stable under normal temperature and pressure.

【PREVENTIVE MEASURES】
Ventilation: Normal room ventilation is okay for limited use. Use adequate ventilation to keep airborne concentrations low.
Respirators: A respiratory protection program that meets OSHA’s 29 CFR 910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator’s use.
Protective Clothing: Wear appropriate protective clothing and gloves to prevent skin exposure.
Eye Protection: Wear appropriate protective eyeglasses or chemical safety goggles.

【PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING】
Handling: Wash thoroughly after handling. Minimize dust generation and accumulation. Avoid contact with eyes, skin. Avoid ingestion and inhalation. Use with adequate ventilation.
Keep container tightly closed.
Storage: Store in a tightly closed container. Store in a cool, dry and well-ventilated place. Store protected from moisture. No special precautions indicated.

【ACCIDENTAL RELEASE MEASURES】
General information: Use proper personal protective equipment.
Spills/Leaks: Contain and clean spilled material by vacuum or broom sweeping and remove to suitable disposal container. Clean up spills immediately. Avoid generating dust conditions. Provide ventilation.

【WASTE DISPOSAL METHOD】
Must consult state and local hazardous waste regulations to ensure complete and accurate classification. Dispose of in accordance with any local, state, and federal regulations. Prevent run-off to sewers.
RCRA P-Series: None listed
RCRA U-Series: None listed

【TRANSPORTATION INFORMATION】
US DOT: No information available

【REGULATORY INFORMATION】
Hazard definitions as defined by the Occupational safety and Health Hazard Communication Standard (CFR Section 1910.1200) are:
---- combustion liquid ---- flammable aerosol ---- oxidizer ---- compressed gas ---- explosive
---- pyrophoric ---- flammable gas ---- health hazard ---- unstable
---- flammable liquid ---- organic peroxide ---- water reactive ---- flammable solid
Based on information presently available, this product does not meet any of the hazard definitions of 29 CFR Section 1910.1200.

SARA 313
As of the preparation date, this product did not contain a chemical or chemical subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372.

NFPA 704 Hazard Codes
Health: 0 Flammability: 0 Reactivity: 0 Special Hazard: -
Signals: Least – 0 Slight – 1 Moderate – 2 High – 3 Extreme – 4


  CAS Registry Number:

1327-41-9;101707-17-9;11097-68-0;114442-10-3

  Synonyms: ;Aluminum chlorohydrate (anhydrous);Aluminum hydroxychloride;Aluminum oxychloride;ACH 325;ACH 331;ACH 7-321;Aloxicoll;Aluminol ACH;Aluminum chlorhydrate;Aluminum chlorhydroxide;Aluminum chloride hydroxide;Aluminum chloride hydroxide oxide, basic;Aluminum chloride oxide;Aluminum chlorohydrol;Aluminum chlorohydroxide;Aluminum hydroxide chloride;Aquarhone 18;Astringen;Astringen 10;Banoltan White;Basic aluminum chloride;Basic aluminum chloride, hydrate;Berukotan AC-P;Cartafix LA;Cawood 5025;Chlorhydrol;Chlorhydrol Micro-Dry;Chlorhydrol Micro-Dry SUF;Dialuminium-chlorid-pentahydroxid;E 200;E 200 (coagulant);Gelsica;HPB 5025;Hessidrex WT;Hydral;Hydrofugal;Kempac 10;Kempac 20;Kemwater PAX 14;Locron;Locron P;Locron S;Nalco 8676;OCAL;Oulupac 180;PAC;PAC (salt);PAC 250A;PAC 250AD;PACK 300M;PALC;Paho 2S;Sansudor;UNII-HPN8MZW13M;Wickenol cps 325;Aluminum chloride, basic;[AL2(OH)nCL6-n]m;aluminum trichloride;Polyaluminum chloride;Poly-Aluminium Chloride(PAC);Poly aluminium chloride;
  Molecular Formula: Al2Cl(OH)5
  Molecular Weight: 174.45
  Molecular Structure: 1327-41-9;101707-17-9;11097-68-0;114442-10-3 Polyaluminium Chloride

  Company: Unitech Chemicals (Zibo) Ltd.---Unisweet (Shandong) Sucralose Manufacturing Co.,     [ China ]        
  Contact: lavender
  Tel: 0086-533-7217335
  Fax: 0086-533-7217339
  Email: lavender.yu@unitechzibo.com
Disclaimer statement:The information and data included above have been realized by the enterprises and compiled by the staff, and are subject to change without notice to you. The Chemnet makes no warranties or representations whatsoever regarding the facticity, accuracy and validity of such information and data. In order to ensure your interest, we suggest you chose the products posted by our gold suppliers or VIP members.