Zhejiang Changming Chemical Products Co.,Ltd.

powder coating

• Category :

  Agrochemicals/Other pesticide

• CAS NO :

• EC NO :

• Molecular Formula :

• Molecular Weight :

• Main Specifications :

• Product description :

  Introduction:

  l          This type of thermosetting powder coatings are applicable to thermal transfer printing process.

  l          The cured coating after the thermal transfer printing process, can be clear veins, beautiful color of patterns.

  Applications:

  Can be widely used in aluminum windows and doors, indoor metal furniture, security doors, car painting, etc.

  Features:

  This powder coating can reach the general performance requirements, the performance of its features are applicable to thermal transfer technology. The cured coating after the thermal transfer process, can be clear veins, beautiful color of patterns. And the thermal transfer film is easy to remove, no residual traces, can be adjusted according to the different thermal transfer process recipe to achieve the best results.

  Technical Data:

  Powder Property	Gravity	1.2~1.8g/cm3
  	Particle Size	General 30~38um，<64um >99%. If any special needs, can adjust
  	Volatile	〈1%
  	Soft Point	60~95℃ depend on the color and gloss
  	Fluidity	Good flow properties and transport properties
  	Storage Stability	Store under 30℃, with the shelf life of 12 months
  Film Property	Coverage	8 -12 m 2 /Kg ， film thickness 70 μm （100% powder calculate）
  	Accelerated Aging	ASTM-G151	Pass
  	Impact	ASTM-D2794	Pass
  	Flexibility	ASTM-D4145	≤ 3 mm
  	Cup Convex	GB/T 9753	>6mm
  	Adhesion	ASTM-D3359	0 Grade
  	Hardness	ASTM-D3363	>80
  	Poach	GB/T 1733/1993	No foaming, no color change
  	Acids	ASTM-D3260	Pass
  	Solvent	ASTM-D2248	Pass
  	Film Thickness	60-70μm
  	Salt Spray	ASTM-B117	1000 hours		Pass
  	Heat Resistant	GB/T 1740	1000 hours		Pass
  Application Condition	Pretreatment	Steel		Phosphating
  		Inspection requirements of the pre-treatment testing once every two hours
  	Spray	This series of products for the following spray method: electrostatic spray; friction electrostatic spray;electrostatic fluidized bed coating (Require in advance); hot dipping fluidized bed (Require in advance);etc.
  		Note: the quality of the spray test at least once every two hours
  	Curing	Recommend 200℃ x 10 minutes, 180℃ x 15 minutes

   

  Packing and Storage:

  Polyethylene bag and paper carton, net weight: 20kg. Non-hazardous materials, can be transported by variety of ways. Should avoid direct sunlight and avoid damp heat, avoid contact with chemical substances.

   

  Warranty Policy: The surface preparation and application procedures and other factors that affect performance are beyond our control.

  Changming assumes no liability for coating failure other than to supply replacement material for the coating shown to be defective.

  Do not use this product until the current material safety data sheet has been read and is fully understood. Changming shall not be liable for any injuries, damages or other losses deriving directly or in consequence of purshaser's use of product. Purchaser shall determine the suitability of this product for his own use, and thereby assumes all risks and liabilities in connection therewith.