BT-104 Enameled Wire Stripper

• Post Date:

  Aug 16,2013

• Expiry Date:

  Feb 12,2014

• Detailed Description:

  
  
  BT-104 Enameled Wire Stripper
  
  
  
  ■ Be applicable to depainting for motor, transformer, voice coil of the line of AI (200), PI (220),and other
  high temperature enameled wire;
  ■ Must be heated to 380 - 450 ℃;
  ■ Environmental protection (qualified by RoHs test), fast, 3 - 5 seconds to remove.
  
  
  
  ■ BT－104 Enameled Wire Stripper is a white powder;
  
  
  
  Enamelled wire→Immersed in the solution（heated to 380 – 450℃ ）,10 - 20 seconds
  → wash the wire→ immersed in the BT－122 → wash → solder
  
  
  ■ BT-104 uses 500g / Bottle of strong acid plastic drum,20 bottles/case;
  ■ Stored at 25 ℃ below, airtight container, the shelf life is 6 months;
  ■ Product should be stored to ensure ventilation, drying, to prevent direct sunlight, and isolate the source of fire, away from heat
  
  ■ Avoid exposure, rain, high temperature at transit.
  
  
  
  ■ As this product is used in high temperature conditions,you should pay more attention for safety,you should wear protective gloves, protective clothing, masks, glasses, avoid to contact with skin, eyes, if you are injured,flush with water immediately (severe required medical diagnosis);
  ■ When the heating is beginning, you should cover the container with metal to avoid heating up the melt which due to the uneven heating of the stripping pink splash; Don’t use it until the stripping powder is fully melted and then open the lid;
  ■ After stripping, you should seal the container to avoild the powder absorb water from air. If not, the water will boiling and splash next time.which make the efficiency of stripper lower.
  

• Company:

  BONT Chemical (Dongguan) Co.,Ltd         

• Contact:

  Meiyo

• Tel:

  13427889670

• Fax:

• Email:

  1311178084@qq.com