Grinding Production Line

Introduction of Grinding Production Line: Mill production line used in metallurgy, building materials,chemicals, mining minerals such as grinding materials processing, can be used for feldspar,calcite,talcum, barite, fluorite, rare earth, marble, ceramics, bauxite, manganese, phosphorus ore, red iron oxide, quartz sand, cement clinker, activated carbon, clay, coal gangue, gypsum, silicon carbide, refractory materials,etc.Mohs hardness of 8 or less, humidity less than 6% of non-explosive mineral materials powder processing. Production line process: The whole Grinding Production Linestructure by the host,analysis machine, plumbing fixtures, blower, jaw crusher, bucket elevator, hopper, electromagnetic vibrating feeder, distribution cabinets and other components. Machine work process: a large block of material through the jaw crusher to the desired particle size, by the elevator to the material hopper, then by vibrating feeder continuously fed uniformly quantify the grinding chamber for grinding,After grinding the powder will be taken away by the fan airflow,the analysis machine for grading, in Grinding Production Line with the fineness of the powder will flow into the big cyclone collector, collecting separated, and then the powder discharged. Airflow cyclone collector and then by a large upper return duct suction blower. This machine is the closed loop gas flow system, and is in the positive and negative pressure state circulating. The material to be ground in the grinding chamber has a certain moisture content, the heat generated when grinding mill chamber gas evaporation causes changes of the gas flow,and because the pipe has gap,the outside air is sucked,increase air circulation flow,so through for this by adjusting the fan and the remainder between the host airflow duct to achieve a balance, and the excess gas into the bag filter, the fine powder of the residual gas into the sub-collection down, I purified gas is discharged.