1.Product characteristics
Anionic polyacrylamide is a water-soluble synthetic polymer, which has the properties of flocculation, thickening, shear, resistance reducing and dispersion, etc.. The active groups in molecular can be adsorbed at the interface to change the interface state. It can form hydrogen bonds with a number of substances after affinity and adsorption which enable it to bridge between the adsorbed particles. So that several or even dozens of particles link into large floc to accelerate the particles settlement in suspension, speed up the solution clarification and promote filtering.
2.Quality Index
|
Code |
Appearance |
Solid content (%) |
Hydrolysis degree (%) |
Molecular weight |
Residual monomer content (%) |
Dissolution time(hr) |
|
BMFLOC71415 |
White grain |
≥89 |
Low |
Medium |
≤0.05 |
≤1.5 |
|
BMFLOC72020 |
White grain |
≥89 |
Low |
High |
≤0.05 |
≤1.5 |
|
BMFLOC72520 |
White grain |
≥89 |
Medium |
High |
≤0.05 |
≤1.5 |
|
BMFLOC73020 |
White grain |
≥89 |
Medium |
High |
≤0.05 |
≤1.5 |
|
BMFLOC80512 |
White grain |
≥89 |
Low |
Medium |
≤0.05 |
≤1.5 |
3. Application
1. Industrial wastewater treatment. The effect is significant especially for wastewater with neutral or alkaline pH value, large suspended particles, high concentration and positive charge, such as wastewater of steel plants, electroplating plants, metallurgical plants and the coal washing plant.
2. Drinking water treatment. Use this product to deal with raw water, which has advantages of small dose, low-cost, no secondary pollution, etc.
3. Papermaking additive. It can used as dispersant of long fiber paper, dry strengthen agent, retention and drainage agent and flocculant for papermaking wastewater，etc
4. Instruction for use
1. It's very important to make the efficient dispersion during using, otherwise will cause agglomerate and "fish eyes", dissolving time will be longer.
2. Low-hardness water for use; avoid adopting such tank or pool, which will influence on water quality.
3. Improve the water temperature to accelerate the dissolving velocity, but not exceed 50℃.
4.Stirring will accelerate dissolving, but tough stirring will make the dispersant chain broken and degradation. Shipshape agitator with 200 - 500 rpm is the best choice.
5. Commonly mix the product into 0.05%－0.5%（w/w）solution as reserve.
6.Adjust the optimum dosage of product according to application condition.
5. Product package
25 Kg paper plastic three-in-one compound woven bags, or according to users’ requirement; Its shelf life is 2 years.
6. Attention
The product is moisture absorbent, thus to protect from damp and moist for conservation. It should be stored at a dry and ventilate storehouse, and not be exposed to air and sunshine.
Phone: +86-546-775278
Fax:+86-546-775258
Post Code：257081
E-mail:peter@slcapam.com
Http：www.slcapam.com